Camco’s RV 90 degree Brass Propane Tee connects to a motorhome or RV trailer propane cylinder to allow the connection of an additional propane appliance. It is for use on RVs with 20 lb supply tanks. It has a Type 1 ACME nut x Female POL and Male ACME thread x 1″ -20 male throwaway cylinder thread.
Comments are disabled for this post.
Two fails: check before using The first hose I received was missing the rubber gasket, brass nipple, ball bearing (that seals the gas flow), and spring (holding the ball bearing in the closed position until installed) rendering the hose completely useless. After requesting a return (Thank You Amazon!) and receiving the replacement, I tried using the new hose. It seemed to work OK, but the flames on my BBQ were lower than normal. When I went to remove the hose, the nipple assembly was starting to screw out. When I…
Ok, it works, but might be TOO big 🙂 This hose works well, the ONLY complaint I can think of which is no fault of the seller or the manufacture but my own, is that its too long! I wanted long made sense, but I didn’t realize that meant its gonna hold so much gas in it. the last time I unscrewed it (with the tank off of course) it let out so much gas that it actually set off the LP detector in my camper which killed the pilot light in the fridge and I nearly spoiled my food ! 🙁 So here’s the deal, it works very well, but be…
It seems like others have had this same problem Leaks between the tank fitting and the T. It seems like others have had this same problem. I can’t believe Camco doesn’t pressure test these before they are packaged. As this adapter is installed before your regulator it is subject to more pressure than most of your system. Be sure you test all your fittings with soap & water!