The MFJ-260C is an air cooled, non-inductive Dry Dummy Load, in a perforated metal housing.
It has an SO-239 connector input for any cable with a PL-259 Connector.
It can handle a full 300 watt load for up to 30 seconds, with derating power / time curve to 5 minutes Silk-screened right on the unit for handy reference.
SWR below 1.1:1 to 30 MHz, 1.5:1 from 30 to 650Mhz.
It measures a super compact 2 1/4×2 1/4×7 inches.
Comments are disabled for this post.
VERY handy for testing radios These “perfect antennas” allow a … VERY handy for testing radios These “perfect antennas” allow a 5w transceiver to transmit a SOLID 20 feet. From inside a metal building,on a unused frequency, you won’t really be bothering anybody. See FCC rules about unlicensed radios.
Defective – Open circuit This is supposed to be a 50 ohm dummy load.It is an open circuit, very bad for the finals on a transmitter.The design uses the aluminum case as the ground connection for one end of the resistor. The case must be oxidized of coated.Do not buy this product. You can get the same functionality by not attaching anything to the output of your transmitter.
One of the must have items for any ham radio operator Dummy loads and antenna analyzer are the two tools you’ll go to everytime your radio gives you hiccups. The dummy load simulates a perfect antenna that can be used a reference point.I was originally going to give this a zero star review because it arrived to me open circuit. Inside a dummy load is a resistor. A non-inductive, pulse withstanding resistor, typically of this price level its a carbon composition or a carbon pile with horrific temper coefficients, but still. a 50 ohm 10%…