Very Nice Product I used these on my new Skeeter after viewing a DVD on boat set-up. I try to use these anywhere I need to drill the fiberglass. It is nice to drill into the transducer plate rather than your expensive boat. I have already had to move a transducer. I cut the 18 in plates in two for the transducers and they were plenty large enough, at 9 inches, for any mounting issues.

I cut it in half and it worked great. Way too expensive for a piece of plastic, I’m sure you can find a similar material much cheaper somewhere, but I didn’t have time to mess around searching all over. 18″ was way too wide for my Searay Bowrider because the transom curves slightly. I cut it in half and it worked great. I didn’t do the cleanest job on the silicone in the picture but it works. Because I cut it I had to drill a new mounting hole and when I went to countersink it my drill bit went down to where I wanted so I…